Aligned

Share your giving link and QR code

People give where the link is in front of them: on the screen during the offering, in the bulletin, in the weekly email. Your giving page has one address and one QR code, both ready to copy in a couple of taps.

About 2 minutes Part of Aligned ChurchUpdated November 17, 2026
aligned.church/church
Open **Giving** from the product menu

1/4 · Open Giving from the product menu

Before you start: Your giving application is approved, so your giving page can take a gift.

Good to know

  • Your link is built from your church's web address, shown in Your church → Church → Your web address, and only an owner or admin can change it. Once your church has its Rapid Launch Kit or a ConnectPath, the old giving link keeps working after a change and opens the same page. Before then, a change stops the old link and the QR codes printed with it, so settle the address before you print.
  • Giving page in Giving's left rail has the same link on its Share tab, with Copy, Open, Embed button for a website you run elsewhere, and a QR code you can show right there.
  • Your giving page doesn't need a website, and it keeps working if your website is rebuilt. If Aligned builds your website, its Give section carries the page once at least one fund is active.
  • Planning your Launch? The QR codes on the Launch slides and on the seat stickers open your church's ConnectPath once it's published (until then, a scan opens a page that says “This page isn't active”), and its Give Now button, unless you've renamed it, opens this same page.

If it’s not working

The page says “This page isn't accepting gifts right now”

The giving page needs an approved giving application and at least one active fund. Check the Set up giving card on the Giving overview for where your application stands, and Funds in Giving's left rail for an active fund.

I don't see the Share your giving page card

It appears once your giving is approved. Until then the Overview shows the setup card, and the Share tab of Giving page already has your link.

An old bulletin's QR code or link stopped working

The church's web address changed after it was printed, before your church had its Rapid Launch Kit or a ConnectPath. Press Copy link or Download SVG again and use the new link and code from here on.

Copy link doesn't seem to copy anything

Some browsers block copying in certain windows. Press Open instead and copy the address from the new tab's address bar.

Did this help?

Next, you might want to